Hang Interior Door

Using 40 to 60 grit sandpaper sand down the edges until it fits.

Hang interior door. Screw each hinge to the door frame with a single screw and open the hinges. To hang an interior door first fit the door in the jamb by standing it up in the existing frame and measuring each edge. Better to get it right even if slow you can build up speed as you gain experience hanging doors.

Using a sharp chisel about 1 inch in width chisel a series of 1mm deep notches. Slab doors are commonly used when replacing an old door with the frame still intact or when repurposing an old door such as an antique. When learning how to hang an interior door this is probably the most complicated part.

You should also make sure to cut the bottom of the door by half an inch more than the space between the top of the door and the jamb. Check the rough opening. Ask this old house general contractor tom silva shows a homeowner the proper way to install a pre hung interior door for a closet.

Prop the door in the door frame resting it on wedges so there s the correct gap at the bottom. With a pencil mark where the top and the bottom of the hinges sit on the door. Mark the door where it meets the existing hinge mortises on the jamb.

Measure the height of the opening and then measure the width at both the top and the bottom. Plane or cut it as needed. Then you can attach the hardware and hang your new slab door in the doorframe.

Measure the position for the door handle to make your job easier you can measure the height of the handles of the other interior doors in your house and use the metrics. Open the door and shim the bottom edge of the open door to keep the frame tight against the stops on the other side. Push the door and frame into the opening.